There were a few lessons that I learned at the Arduino Cult induction workshop that I put together this month. One of which was that I needed to simplify my programmer design on the cable end and not wait until I had a full blown product. Revisiting the original I first revised the ftdi boards to use a pinout compatible with the programming end of the rbba. Then I went back to the AT90USB162 based programmer modified the schematic to reduce the parts count.
Then I made it fit into a similar profile.
Then I put together a parts manifest at q25 and found that in spite of the increased parts count it is actually cheaper than the ftdi boards.
Index Quantity Part Number Description Customer Reference Backorder Quantity Unit Price
USD Extended Price
USD
1 50 RHM10KARCT-ND RES 10K OHM 1/8W 5% 0805 SMD 0 0.02340 $1.17
2 25 AT90USB162-16AURCT-ND IC AVR MCU 16K FLASH 32TQFP 0 3.15000 $78.75
3 25 631-1099-ND CRYSTAL 8.0 MHZ SERIES 0 0.48900 $12.23
4 30 PCC220CNCT-ND CAP 22PF 50V CERM CHIP 0805 SMD 0 0.06900 $2.07
5 200 RHM220ACT-ND RES 220 OHM 1/8W 5% 0805 SMD 0 0.02340 $4.68
6 50 RHM22ACT-ND RES 22 OHM 1/8W 5% 0805 SMD 0 0.04080 $2.04
7 100 399-1168-1-ND CAP .10UF 25V CERAMIC X7R 0805 0 0.02670 $2.67
8 50 399-1284-1-ND CAP 1.0UF 16V CERAMIC X7R 0805 0 0.09500 $4.75
9 30 475-1401-ND LED 3MM 570NM GREEN DIFF RADIAL 0 0.05600 $1.68
10 1 AT43301-SU-ND IC USB HUB CTRLR 4PORT 24SOIC 0 1.83000 $1.83
11 25 609-1039-ND CONN RCPT USB TYPE B R/A PCB 0 0.54200 $13.55
Subtotal $125.42